Sound samples from Ian:
One: Percussive sounds using Teezer Tri output with chaotic variation in frequencies.
Two: Dynamic depth synchronization of Teezer.
Three: 3/2 carrier to modulation frequency ratio. Teezer Saw carrier moduled by Tri or Squ wave. Various modulation depths.
Four: Bells and other percussive sounds with Teezer Sin carrier and deep modulation.
Five: Teezer modulated by a VCO with a VC Saw-Tri shaper followed by a Threeler filter. An ADSR drives the shaper and the filter.
Six: A DoubleDekka VCO dynamically modulating a Teezer with Sin out. Various levels of modulation depth and sync.
Seven: Teezer Saw carrier and Tri FM modulation, in unison, various FM depths.
Eight: Demonstration of Teezer sync locking over three octaves with modulation up to 1000%.
Nine: Teezer at low Bias setting. Lin FM from fixed Tri wave. Exp FM from Jerkster chaos generator. VCA and Theeler VCF also controlled from Jerkster.
Ten: A DoubleDekka VCO dynamically modulating a Teezer with Sin out. Various levels of modulation depth and cross coupling.
Eleven: Demonstration of 1000% modulation of Teezer without then with sync. Note minimal pitch shift without sync and minimal timber change with sync.
Notes for 15V building without using different zeners (thanks Dave at www.modularsynthesis.com!)
R28 27k
R116 487k
R119 30k
D203-4 8v2
D205-6 6v2
These are now sent in the kits.
Also, an extra 33p cap is sent for C6. If you have trouble getting symmetry at the triangle top, try using the 33p.
